root@nimblex:~# dmesg | tail -30
con questo comando letto sul sito dei firmware ho avuto questo responso.
mi pare di capire che l'arware venga riconosciuto, è già un successo
ora mi par di capire che il problema sia il firmware.
bene ho letto il wiki, ho letto ciò che mi hai scritto e li ho scaricati , me ne chiede due se non erro.
però non capisco una cosa, devono solo essere presi i due file (ma non hanno nessuna estensione?) e trasportati in /lib/firmware ?
tutto qui?
se è così l'ho fatto.
poi ho ridato quel comando che ho messo su e mi dice ciò che leggi, cioè come se ancora non li vedesse.
Mi sorprende che tutti gli altri firmware che ho in directory hanno estensione .fw o altro, mentre questi niente.
Che ne dici ?
P.S ti assicuro che mi sto documentando.
ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNK1] -> GSI 11 (level, low) -> IRQ 11
PCI: Setting latency timer of device 0000:02:00.0 to 64
acx: found ACX111-based wireless network card at 0000:02:00.0, irq:11, phymem1:0x24020000, phymem2:0x24000000, mem1:0xdfcb8000, mem1_size:8192, mem2:0xdfd40000, mem2_size:131072
initial debug setting is 0x000A
using IRQ 11
acx: need to load firmware for acx111 chipset with radio ID 16, please provide via firmware hotplug:
acx: either one file only (<c>ombined firmware image file, radio-specific) or two files (radio-less base image file *plus* separate <r>adio-specific extension file)
requesting firmware image 'tiacx111c16'
acx: firmware image 'tiacx111c16' was not provided. Check your hotplug scripts
requesting firmware image 'tiacx111'
acx: firmware image 'tiacx111' was not provided. Check your hotplug scripts
acx: reset_dev() FAILED
ACPI: PCI interrupt for device 0000:02:00.0 disabled
acx_pci: probe of 0000:02:00.0 failed with error -5
usb 1-2: new full speed USB device using ohci_hcd and address 3
usb 1-2: configuration #1 chosen from 1 choice
phy1: Selected rate control algorithm 'simple'